Each line in these files consists of one hardware address and name separated by whitespace. The digits of hardware addresses are separated by colons : , dashes - or periods.
Wireshark uses the files listed in Table A. This file has the same format as the ethers file, except addresses are three bytes long. If no exact match from the hosts file or from DNS is found, Wireshark will attempt a partial match for the subnet of the address. While the address must be a full IPv4 address, any values beyond the mask length are subsequently ignored.
A partially matched name will be printed as "subnet-name. For example, " Wireshark searches for plugins in the directories listed in Table A. They are searched in the order listed. If you start a new capture and don't specify a filename for it, Wireshark uses this directory to store that file; see Section 4.
Files and Folders Next. Configuration Files and Folders. Tip A list of the folders Wireshark actually uses can be found under the Folders tab in the dialog box shown when you select About Wireshark from the Help menu. Then, if there is a hosts file in the personal configuration folder, that is read; if there is an entry for a given IP address in both files, the setting in the personal hosts file overrides the entry in the global hosts file.
The settings from this file are read in at program start and never written by Wireshark. When Wireshark is trying to translate an IPX network number to a name, it consults the ipxnets file in the personal configuration folder first. If the address is not found in that file, Wireshark consults the ipxnets file in the system configuration folder. The settings from this file are read in when an IPX network number is to be translated to a name, and never written by Wireshark.
At program start, if there is a manuf file in the global configuration folder, it is read. The entries in this file are used to translate MAC address prefixes into short and long manufacturer names. Each line consists of a MAC address prefix followed by an abbreviated manufacturer name and the full manufacturer name. Prefixes 24 bits long by default and may be followed by an optional length. Note that this is not the same format as the ethers file.
This file contains your Wireshark preferences, including defaults for capturing and displaying packets. It is a simple text file containing statements of the form:. At program start, if there is a preferences file in the global configuration folder, it is read first. Then, if there is a preferences file in the personal configuration folder, that is read; if there is a preference set in both files, the setting in the personal preferences file overrides the setting in the global preference file.
This file contains GUI settings that are specific to the current profile, such as column widths and toolbar visibility. It is read at program start and written when preferences are saved and at program exit. It is also written and read whenever you switch to a different profile. This file contains common GUI settings, such as recently opened capture files, recently used filters, and window geometries.
Wireshark uses the services files to translate port numbers into names. At program start, if there is a services file in the global configuration folder, it is read first. Then, if there is a services file in the personal configuration folder, that is read; if there is an entry for a given port number in both files, the setting in the personal hosts file overrides the entry in the global hosts file.
The settings from these files are read in at program start and never written by Wireshark. Wireshark uses the ss7pcs file to translate SS7 point codes to node names. Get a virtual cloud desktop with the Linux distro that you want in less than five minutes with Shells! With over 10 pre-installed distros to choose from, the worry-free installation life is here! Whether you are a digital nomad or just looking for flexibility, Shells can put your Linux machine on the device that you want to use.
Click here for more info. I don't appear to have a global preferences file either. It could be that the global preferences are not used by default, and they need to be enabled or otherwise created manually. Thread Tools. BB code is On. Smilies are On. All times are GMT The time now is AM. Twitter: linuxquestions. Open Source Consulting Domain Registration.
0コメント